Front Brake Caliper Assembly 45100-392-003 Honda CB750

  

Front Brake Caliper Assembly - 45100-392-003 - Honda CB750. Complete Honda front brake caliper assembly.

This caliper assembly does not come pre-assembled, it includes all the parts shown in the photo. This presents a solution to these questions.... What do I do if my piston is heavily pitted and so is the inside of my caliper? " or "my pads are toast, my bleeder valve is seized and so is my piston! Yes, some of us just start cleaning, soaking and scrubbing all the parts and replace individual parts such as the piston, seal and bleeder valve but if you want your caliper looking and working like new and you want to save a lot of time, get the complete caliper. Finish the job in minutes rather than hours! 2 - Mounting Bolts 2 - Washers (for mounting bolts) 1 - Cotter Pin 1 - Rubber Cap for bleeder valve 1 - Piston 1 - Bleeder Valve 1 - Piston Seal 1 - Brake Pad A 1 - Brake Pad B 1 - Caliper A 1 - Caliper B. Replaces Honda Part Number: 45100-392-003. Installation Note: If there is any black paint over-spray inside the caliper it should be removed with brake fluid or an equivalent solvent prior to installing. Some steel wool will clean it up easily.

Note: Brake calipers changed from year to year. There is another very similar looking caliper that was used on earlier models from early 70's.

Please check the mounting spacing listed below. Mounting Spacing - 51mm (2) measured from center to center. The item "Front Brake Caliper Assembly 45100-392-003 Honda CB750" is in sale since Friday, April 12, 2019. This item is in the category "eBay Motors\Parts & Accessories\Motorcycle Parts\Brakes & Suspension\Calipers & Parts".

The seller is "4into1motorcycleparts" and is located in South San Francisco, California. This item can be shipped worldwide.

• Honda Part Number: 45100-392-003
• Type: Caliper
• Manufacturer Part Number: CA-01
• Number of Pistons: 1
• Finish: Black
• Placement on Vehicle: Front
• Brand: Front Brake Assembly